Here''''s the raw scan, after basic colour correction is done. As usual, I scanned at 600 dpi and downsampled it to 300 dpi: STEP 1：
下面是做过基本的调色之后的图。和通常一样，扫描@600dpi,缩小到300dpi
Step 2:
Masking the skin out for smoothing. Use the quick mask tool and the brush to paint in the mask. Red colour is the selected area. Use soft edged brushes to paint along the edges,,,,,try not to paint right to the edge. STEP 2：
选出想模糊的部分：进入快速蒙板，用画笔，红色是选择的区域，用软笔触的画笔涂抹选区里的靠近边缘的地方，注意不要离边缘太近了。
Step 3
After painting in the skin, save your selection as an alpha channel. I named this layer as "skin" STEP 3：
选择好了区域之后，保存选区为alpha通道，命名为skin
Step 4
Here''''s what my scan looked like with all areas of the skin masked. STEP 4：
之后你会得到一个这样的图(在快速蒙板模式下)
Here''''s what the scan looked like out of the quick mask mode. 在退出快速蒙板之后，你会得到一个类似于这样的图。
